Table of Contents
Advertisement
config system login <login id>
Change the login name to enter into CLI.
The default login name is 'admin'. It is suggested to change the login
ID for security reason, furthermore to prevent illegal entry.
config system password <password>
Change the login password to enter into CLI.
The default login password of this router is 'admin' . It is suggested to change the
login password for security reason, furthermore to prevent illegal entry.
config system show
Display the current login name, password and router's host name.
exit
Exit to the AT command mode.
hwinfo
Display the current hardware information.
ping <IP address>
Send an ICMP (Internet Control Message Protocol) echo to the host IP address.
The ping is a useful internet program to check the if the specified IP address host device is alive
or not. If the destination host is alive then the router should receive the echo from the host and
display the message. Otherwise if the destination host did not reply after time out, the router will
display timeout message.
qconfig
Quick configuration of the router to connect the internet.
The qconfig is a very useful command to setup the minimum requirement of the router. After the
quick configuration procedure you should be able to connect into the internet and place voice
call. The qconfig will request you to enter IP address, IP mask, switch type, directory number,
and remote destination number. Please see Chapter 5 for detail operation.
ISDN Router Manual V.1.1
29
Advertisement
Table of Contents
