Using The Axlink Mini-Xlr Connector For Data And Power (Axt-Mcp); Using The Axlink Mini-Xlr Connector And External 12 Vdc Power Supply (Axt-Mcp) - AMX AXD-MCP Instruction Manual

Central Controller's power supply. Refer to the Specifications section on page 1 for more
information.
Wiring Guidelines
Wire Size Maximum Wiring Length
18 AWG
20 AWG
22 AWG
24 AWG
If you install the touch panel farther away from the Central Controller than recommended in the
Wiring Guidelines table, connect an external 12 VDC power supply to the panel as shown in the
wiring diagrams in this section.

Using the AXlink mini-XLR connector for data and power (AXT-MCP)

Connect the Central Controller's AXlink connector to the mini-XLR connector (male) on the rear
panel of the TiltScreen mini-touch panels for data and 12 VDC power, as shown in FIG. 8.
2
1
4
4 - PWR (+) - Red
3 - AXP
2 - AXM
1 - GND (-) - Black
FIG. 8 Mini-XLR connector wiring diagram

Using the AXlink mini-XLR connector and external 12 VDC power supply (AXT-MCP)

Connect the Central Controller's AXlink connector to the mini-XLR connector and external
12 VDC power supply to the rear panel of the AXT-MCP, as shown in FIG. 9.
2
1
4
4 - PWR (+) - Red
3 - AXP
2 - AXM
1 - GND (-) - Black
FIG. 9 Mini-XLR connector to external 12 VDC power supply and Central Controller wiring diagram
5.5" Color Passive Mini-Touch Panels
121.00 feet (36.88 m)
153.11 feet (46.67 m)
95.46 feet (29.10 m)
60.17 feet (18.34 m)
4-pin mini-XLR connector
on AXT-MCP (external view)
3
- White
- Green
4-pin mini-XLR connector
on AXT-MCP (external view)
3
- White
- Green
Installation
1 GND (-) - Black
2 AXM - Green
3 AXP - White
4 PWR (+) - Red
Central Controller
PWR (+) - Red
GND (-) - Black
1 GND (-) - Black
2 AXM - Green
3 AXP - White
4 PWR (+) - Red
Central Controller
9