Ospf Application Example - Alcatel 060320-10, Rev. B Configuration Manual

OSPF Application Example

OSPF Application Example
This section will demonstrate how to set up a simple OSPF network. It uses three routers, each with an
area. Each router uses three VLANs. A backbone connects all the routers. This section will demonstrate
how to set it up by explaining the necessary commands for each router.
The following diagram is a simple OSPF network. It will be created by the steps listed on the following
pages:
VLAN 12
Interface 12.x.x.x
Area 0.0.0.2
Router 2
Router ID 20.0.0.1
VLAN 20
Interface 20.0.0.1
page 1-32
Router ID 1.1.1.1
Backbone Area
(Area 0.0.0.0)
VLAN 23
Interface 23.x.x.x
Three Area OSPF Network
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide
VLAN 10
Interface 10.0.0.1
Area 0.0.0.1
Router 1
VLAN 31
Interface 31.x.x.x
Configuring OSPF
Area 0.0.0.3
Router 3
Router ID 3.3.3.3
VLAN 30
Interface 30.0.0.1
March 2011