Alcatel 060320-10, Rev. B Configuration Manual page 203

Configuring PIM
The display for dense mode is similar to the one shown here:
-> show ip pim dense
Status
Source Lifetime
State Refresh Interval
State Refresh Limit Interval = 0,
State Refresh TTL
(additional table output not shown)
For more information about these displays, see the "PIM Commands" chapter in the OmniSwitch CLI
Reference Guide.
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide
= enabled,
= 210,
= 60,
= 16
March 2011
Quick Steps for Configuring PIM-DM
page 6-7