OSPF Application Example
OSPF Application Example
This section will demonstrate how to set up a simple OSPF network. It uses three routers, each with an
area. Each router uses three VLANs. A backbone connects all the routers. This section will demonstrate
how to set it up by explaining the necessary commands for each router.
The following diagram is a simple OSPF network. It will be created by the steps listed on the following
pages.
VLAN 12
Interface 12.x.x.x
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
Area 0.0.0.2
Router 2
Router ID 20.0.0.1
VLAN 20
Interface 20.0.0.1
page 1-32
VLAN 10
Interface 10.0.0.1
Area 0.0.0.1
Router 1
Router ID 1.1.1.1
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
Backbone Area
(Area 0.0.0.0)
VLAN 23
Interface 23.x.x.x
Three Area OSPF Network
OmniSwitch 6600 Family Advanced Routing Configuration Guide
Configuring OSPF
VLAN 31
Interface 31.x.x.x
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
OmniSwitch 6648
Area 0.0.0.3
Router 3
Router ID 3.3.3.3
VLAN 30
Interface 30.0.0.1
March 2005