Alcatel 060320-10, Rev. B Configuration Manual page 21

Configuring OSPF
9
Enable the OSPF interfaces using the ip ospf interface admin-state command. For example:
-> ip ospf interface vlan-5 admin-state enable
10
You can now display the router OSPF settings by using the
ated is similar to the following:
-> show ip ospf
Router Id
OSPF Version Number
Admin Status
Area Border Router ?
AS Border Router Status
Route Tag
SPF Hold Time (in seconds)
SPF Delay Time (in seconds)
MTU Checking
# of Routes
# of AS-External LSAs
# of self-originated LSAs
# of LSAs received
External LSDB Limit
Exit Overflow Interval
# of SPF calculations done
# of Incr SPF calculations done
# of Init State Nbrs
# of 2-Way State Nbrs
# of Exchange State Nbrs
# of Full State Nbrs
# of attached areas
# of Active areas
# of Transit areas
# of attached NSSAs
Default Route Origination
Default Route Metric-Type/Metric = type2
BFD Status
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide
show ip ospf
= 46.46.46.46,
= 2,
= Enabled,
= No,
= Enabled,
= 0,
= 10,
= 5,
= Disabled,
= 197,
= 0,
= 2,
= 102,
= -1,
= 0,
= 2,
= 0,
= 0,
= 0,
= 0,
= 2,
= 1,
= 1,
= 0,
= 1,
= none,
= Disabled
March 2011
OSPF Quick Steps
command. The output gener-
Router ID
As set in Step 4
page 1-5