Table of Contents
Advertisement
.........................................................................................................................................................................
If the installation is a Primary SMS, the installation will proceed immediately to
16
If the installation is either a Secondary SMS or a Compute Server installation, you will be
asked to enter the IP address for either the Primary SMS or the SMS to which the Compute
Server will home. The program will perform the additional steps required and proceed to
Step
20.
If the Secondary SMS cannot contact the Primary SMS, or the Compute Server cannot
contact its associated SMS, the installation program prompts you to retry with a different
IP address. If you cannot enter a valid IP address, you must terminate the installation
program using the Task Manager. The inability to contact the specified IP address may
indicate a network problem that must be corrected before proceeding with the installation.
For security reasons, the Secondary SMS must be installed/upgraded within 7 days of
installing/upgrading a Primary SMS. After more than 7 days, the installation or upgrade of
a secondary will fail because the Primary SMS does not allow the Secondary SMS to
copy/replicate the database. To allow database replication, you must open a command line
window on the primary, cd to the installation directory, and enter the following command:
local\bin\allowSecondarySetup
For Secondary SMS or Compute Server installations, the SMS services are
Result
initialized. Go to
.........................................................................................................................................................................
For Primary SMS installations, the installation program begins to initialize the database.
17
This process will take several minutes.
A master key is generated and displayed in the lower half of the SMS Setup screen. The
purpose of the master key is to protect the root certificate used to authenticate
communication between the SMS and the Brick devices that it manages. Write the master
key down and keep it in a secure place. You will need the key to recover if you should
forget the Administrator password and become locked out of the SMS.
Result:
The installation program displays the Enter Admin ID window so that you may
create an SMS Administrator ID and password.
.........................................................................................................................................................................
Create an Administrator ID and password by entering information into the following fields:
18
•
Admin ID
. This is the initial ID used to log into the SMS. It can contain a maximum
of 16 characters. Keep a record of the Admin ID in a secure place. You will need it to
log into the SMS after installation is complete. Once you log in with this initial ID,
other administrator IDs can be created, if desired.
•
. The password is needed to complete the login. Enter the password, and
Password
then enter it again for verification purposes. The password can contain up to 42
characters. It is case-sensitive, so you must enter the password exactly the same each
time.
Step
20.
To Install the SMS Application (Clean Installation)
...................................................................
Step
17.
13
Advertisement
Table of Contents
