Table of Contents
Advertisement
■
Audio Return Ch (ARC)
Off
Auto:
The audio signal from your TV tuner can be sent to
the HDMI OUT of the AV receiver.
The audio return channel (ARC) function allows an ARC
capable TV to send the audio stream to the HDMI OUT of
the AV receiver. To use this function, you must select the
TV/CD input selector and your TV must support ARC
function.
Note
• If you set "Audio Return Ch" to "Auto", the "Audio Selector"
settings of the TV/CD input selector will be automatically
switched to "ARC"
(➔
• The "Audio Return Ch" setting can be set only when the above
"HDMI Ctrl (RIHD)" setting is set to "On".
• This setting is set to "Auto" automatically when the above
"HDMI Ctrl (RIHD)" is set to "On" first time.
■
LipSync
Off
On
This function allows the AV receiver to automatically
correct any delay between the video and the audio, based
on the data from the connected monitor.
Note
• This function works only if your HDMI-compatible TV supports
HDMI Lip Sync.
After changing the settings of the "HDMI Ctrl
(RIHD)", "HDMI Through" or "Audio Return Ch",
turn off the power to all connected pieces of equipment
and then turn them on again. Refer to the instructions
for all connected pieces of equipment.
En
40
page 38).
Using the Audio Settings
You can change various audio settings from the Home
page 29).
menu
(➔
1
Press RECEIVER followed by HOME.
2
Use / and ENTER to select "Audio", and then
use / / /
to make the desired selection.
Note
• These settings are disabled when:
– a pair of headphones is connected, or
– the "Audio TV Out" setting is set to "On"
an input selector other than HDMI is selected, or
– "HDMI Ctrl (RIHD)" is set to "On"
you're listening through your TV speakers.
Tone Control
■
Bass
–10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
–10 dB to 0 dB to +10 dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for Speakers A and B
front speakers, except when the Direct listening mode is
selected.
Operating on the AV receiver
1
Press TONE on the AV receiver repeatedly to
select either "Bass" or "Treble".
2
Use + and – on the AV receiver to adjust.
Note
• To bypass the bass and treble tone circuits, select the Direct
listening mode.
Speaker Levels
■
Subwoofer Level
–15 dB to 0 dB to +12 dB in 1 dB steps
■
Center Level
–12 dB to 0 dB to +12 dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to Standby. To save the setting you made
here, go to "Level Cal (Level Calibration)"
before setting the AV receiver to Standby.
Note
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to "No" or "None" in the "Sp Config
(Speaker Configuration)"
(➔
page 39) and
(➔
(➔
page 39) and
(➔
page 35)
page 34) cannot be adjusted.
Hide quick links:
Advertisement
Table of Contents
