Remote Controller Setup; Lock Setup; Using The Audio Settings - Onkyo HT-R990 Instruction Manual

Remote Controller Setup

Main menu
Remote Mode Setup
See "Looking up for Remote Control Code"
(➔ page 64).

Lock Setup

With this preference, you can protect your settings by
locking the setup menus.
Main menu
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.

Using the Audio Settings

You can change various audio settings from the Home
menu (➔ page 39).
1
Press RECEIVER followed by HOME.
2
Use q/w and ENTER to select "Audio", and then
use q/w/e/r to make the desired selection.
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
– the "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Tone Control Settings
■
Bass
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct or THX listening mode is selected.
Operating on the AV receiver
1
Press TONE repeatedly to select either "Bass" or
"Treble".
2
Use + and – to adjust.
Downloaded from www.Manualslib.com
Remote Controller Setup
Lock Setup
(➔ page 55).
(➔ page 54) and
manuals search engine
Speaker Levels
■
Subwoofer Level
–15dB to 0dB to +12dB in 1 dB steps.
■
Center Level
–12dB to 0dB to +12dB in 1 dB steps.
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to "Level Calibration"
setting the AV receiver to standby.
Note
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to "No" in "Speaker Configuration"
page 44) cannot be adjusted.
(➔
Audyssey
■
Audyssey
See "Audyssey" in "Source Setup"
■
Dynamic EQ
See "Dynamic EQ" in "Source Setup"
■
Dynamic Volume
See "Dynamic Volume" in "Source Setup"
Note
• These technologies can be used when all the following
conditions are met:
– Room Correction and Speaker Setup is completed. Note that
"Audyssey" requires the "Audyssey 2EQ Full Calibration"
method.
– Any listening mode other than Direct is selected.
– A pair of headphones is not connected.
• The setting is stored individually for each input selector.
page 45) before
(➔
page 48).
(➔
page 48).
(➔
page 49).
(➔
En
57