Remote Controller Setup
Main menu
Remote Controller Setup
Remote Mode Setup
See "Looking up for Remote Control Code"
(➔
page 69).
Lock Setup
With this preference, you can protect your settings by
locking the setup menus.
Main menu
Lock Setup
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.
Using the Audio Settings
You can change various audio settings from the Home
page 40).
menu
(➔
1
Press RECEIVER followed by HOME.
2
Use / and ENTER to select "Audio", and then
use / / /
to make the desired selection.
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
– the "Audio TV Out" setting is set to "On"
– "HDMI Control(RIHD)" is set to "On"
you're listening through your TV speakers.
Tone Control Settings
■
Bass
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct, Pure Audio or THX listening
mode is selected.
Operating on the AV receiver
1
2
Note
• To bypass the bass and treble tone circuits, select the Direct,
Pure Audio or THX listening mode.
• This setting is not available when the multichannel Analog input
is selected.
Speaker Levels
■
Subwoofer Level
–15.0dB to 0.0dB to +12.0dB in 0.5 dB steps.
■
Center Level
–12.0dB to 0.0dB to +12.0dB in 0.5 dB steps.
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to "Level Calibration"
setting the AV receiver to standby.
Note
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to "No" or "None" in
"Speaker Configuration"
Dolby Volume
■
Dolby Volume
See "Dolby Volume" of "Audio Adjust"
page 59).
(➔
Note
(➔
page 58) and
• This setting cannot be used in either of the following cases:
– Pure Audio or Direct listening mode is selected.
– the multichannel analog input is selected.
– any of the THX listening modes is selected, with "Loudness
Plus" set to "On" or "Preserve THX Settings" set to "Yes"
(➔
• When "Dolby Volume" is set to "On", the "Dynamic EQ" and
"Dynamic Volume" settings of all input selectors are switched
to "Off".
Press TONE repeatedly to select either "Bass" or
"Treble".
Use + and – to adjust.
(➔
(➔
page 47) cannot be adjusted.
page 49).
page 48) before
(➔
page 51).
En
61