Ice Transport Tube Replacement - Follett 110 Series Installation & Service Manual

Ice transport tube replacement

Top mount ice machines, model C/E110CT400A/W
!
Only use tubing supplied by Follett Corporation.
1
Ice transport tube replacement
Models C/E110FB400A/W, C/E110CR400A/W
! Correct installation of ice transport tube is critical to Satellite-fill icemaker performance. Replacement
ice transport tubes for Satellite-fill icemakers must be insulated and run continuously from icemaker
to dispenser with no dips or bends with a radius of less than 153mm (6").
1. Remove top and rear access panel from dispenser (lower front panel in
freestanding unit).
2. Disconnect existing ice tube from engaging pin on transport tube bracket in ice
storage bin evaporator and pull down through dispenser chase.
3. Disconnect opposite end of tube from icemaker.
4. Run end of new ice transport tube with 5mm (3/16") hole through ice transport
tube knock-out, (Fig. 5G) in back of dispenser or through counter into bottom of
dispenser, being careful to avoid any bends with less than 153mm (6") radius.
5. Insert tube in internal chase in rear inside corner of dispenser (left side as you
face dispenser) and push up into storage area.
6. Push the 5mm (3/16") hole near end of tube into pin on ice tube bracket
(see drawing below).
Steps 7-8 for units with Satellite-fill icemakers only
7. Install supplied insulation to run of transport tube required for your site, leaving
approximately 51mm (2") of tube exposed at free end.
8. Check that insulated tube runs continuously uphill to dispenser with no dips.
3
2
19
TIGHTEN
CLAMP
SCREW
4
5mm (3/16")
dia. hole
Section A – A
26mm
(1")
A A