Plot Configure Menu - HP 8590 E-Series User Manual

4. Turn on the spectrum analyzer and the plotter.
5. The plotter usually resides at device address 5. To configure the plotter address to 5 on the
spectrum analyzer, press:
P l o t Config
P l t P o r t
PLOTTER ADDRESS
5
6. Referring to Figure 6-7 select the plotter configuration for your spectrum analyzer by
pressing the appropriate keys:
P l o t Config
PLTS/PG 1 2 4
COPY DEV PRNT PLT
PLT->LJT ON OFF
6-8 Printing and Plotting
Figure 6-7. Plot Configure Menu
Press this key to access the configuration menu.
Press this key to access the plotter menu.
Press this key to access the plotter configuration menu.
that HPIB is underlined)
(
SO
Press this key to access the configuration menu.
Press this key to access the plotter configuration menu,
Press this key to underline the number of plots per page desired.
Choose 1, 2, or 4 plots per page (see Figure 6-2).
If two plots per page are chosen, this function allows you to select
the location on the paper for the plotter output. The upper and
lower sections of the softkey label graphically represent where the
plotter output will be located.
Press the softkey until the rectangular marker is in the desired
section of the softkey label.
If four plots per page are chosen, this function allows you to select
the location on the paper for the plotter output. The quadrant of
the softkey label graphically represents where the plotter output will
b e l o c a t e d .
Press the softkey until the rectangular marker is in the desired
section of the softkey label.
Press this key so that PLT is underlined.
Make sure that is underlined unless you are plotting to a
OFF
laserjet.
Press this key to copy the spectrum analyzer display to the plotter.