Specifications - Follett HCD1400N Operation And Service Manual

Specifications

Electrical
Separate circuit and equipment ground required.
Evaporator unit
Standard electrical – 115/60/1
Maximum fuse – 15 amps
Amperage – 6 amps
Condenser unit
Standard electrical – 220V, 60Hz, 1 phase
Maximum fuse – 40 amps
Amperage – 21.4 amps
Evaporator plumbing
3/8" OD push-in water inlet
3/4" MPT
Notes: 3/4" vented drain line must slope a minimum of 1/4" per foot (6mm per 30.4cm run).
Drain to be hard piped and insulated.
Water shut-off recommended within 10 feet (3m).
Follett recommends installation of Follett water filter system (part# 00130286) in icemaker
inlet water line.
Ambient
Evaporator unit
Air temperature
Water temperature
Water pressure
Condenser unit
Air temperature
Refrigeration
3/8" liquid line
5/8" suction line
Note: Rack system installations require a reserve capacity of 10,000 BTU/hr at
0˚F (-18˚C) evaporator temperature.
Evaporator pressure regulator (not supplied) is required.
Weight
Evaporator unit
190 lbs (88kg)
Condenser unit
385 lbs (175kg)
100˚F/38˚C max.
90˚F/32˚C max.
70 psi max. (483 kPa)
120˚F/49˚C max.
50˚F/10˚C min.
45˚F/7˚C min.
10 psi min. (69 kPa)
– 20˚F/-29˚C min.
Ice production
Icemaker capacity/24 hrs.
Ambient Air Temperature F/C
60
F
C 16
50 1231
559
10
1182
60
537
16
70 1146
21 520
1110
80
504
27
90 1074
32 488
5
70 80
90 100
21 27 32 38
1206 1163 1128 1098 lbs
548 528 512 499 kg
1157 1127 1088 1055 lbs
525 512 494 479 kg
1121 1091 1048 1012 lbs
509 495 476 460 kg
1085 1055 1008 969 lbs
493 479 458 440 kg
1049 1019 968 926 lbs
476 463 440 421 kg