Follett HCC1400W Operation And Service Manual page 6

Dimensions and clearances
Entire front of icemaker must be clear of obstructions/connections to allow removal.
1" (26mm) clearance above icemaker for service.
1" (26mm) minimum clearance on sides.
The intake and exhaust air grilles must provide at least 170 sq in (968 sq cm) of open area.
Air-cooled model HCC1400A icemakers – 18" (458mm) minimum clearance between discharge and air
intake-grilles.
Front View
Air intake
Side View
21.28" (541mm)
23.50"
(597mm)
CORPORATION Easton Pennsylvania
MODEL SERIAL NO PART NO
SINGLE
FULL LOAD AMPS VOLTS HZ PHASE
208264 MOTOR COMPRESSOR THERMALLY PROTECTED
Stock Module Identification Plate
Module No. REFRIGERANT CHARGE OZ
Product DESIGN PRESSURE HIGH SIDE LOW SIDE PSIG
Service No.
MIN. BRANCH CIRCUIT AMPACITY AMPS
U L U L NSF MADE IN
R R THE USA
MAX. BRANCH CIRCUIT FUSE SIZE AMPS C
21.05" (535mm)
23.8" (580mm)
6
Ice transport hose connection
NEMA 6-20
right angle
Air exhaust
both sides
G
1/4" FPT
condenser inlet
1/4" FPT
condenser drain
15.56"
(395mm)
6.97"
(177mm)
2.53"
(64mm)
2.72"
(69mm)
3/8" OD push-in water inlet
3/4" MPT drain
Back View
Air exhaust
29.63" (753mm)
2.43" (62mm)