Follett HCC1400W Operation And Service Manual page 27

Ice machine disposition
Legend:
ON OFF ON or OFF
7. Ice machine is not making ice.
Drain clog.
8. Ice machine is making ice.
Excessive water in bin or
coming into bin from transport
tube.
9. Ice machine is making ice.
Excessive water in bin or
coming into bin from transport
tube.
11. Ice machine is not making ice.
Lo water.
Possible causes
FLASHING
1. Drain hose kinked or plugged
causing water to back up.
2. Improper floor drain routing/pitch
causing water to back up.
3. High TDS levels and leaking
drain solenoid may cause an
errant drain clog.
4. No vent in drain line causing
backup during a purge.
1. Defective water feed solenoid
valve. Stuck in open position.
1. Failed water sensors. Processor
assumes there is no water when
there is water.
2. Blocked reservoir vent.
1. Water supply is turned off.
2. Low water pressure.
3. Defective water feed solenoid
valve. Stuck in closed position.
4. No water feed output from
PC board.
27
Corrective actions
1. Remove kink or blockage from
drain hose.
2. Re-route floor drain.
3. Clean area around drain sensor and/
or replace Drain solenoid valve.
4. Add vent to drain line.
1. Replace water feed solenoid valve.
1. Clean or replace water probe
assembly. Check wiring connections.
2. Clean or replace vent tubes.
1. Turn water supply on. If evaporator
was completely empty the reset
button may have to be pressed to
restart the ice machine.
2. Ice machine will eventually start
when water reaches normal lo level.
3. Replace water feed solenoid valve.
4. Replace PC board.