Quick Set-Up Guide; Detailed Set-Up Guide; Battery Installation - La Crosse Technology WT-5442 Instruction Manual

variance in the quartz. However, the clock will adjust the quartz timing over the
course of several days to be very accurate; under 0.10 seconds per day.

QUICK SET-UP GUIDE

1) Insert two AA batteries into the remote sensor.
2) Insert three AA batteries into the projection alarm and/or plug into
wall.
Note: When starting or restarting your projection alarm the remote
sensor must be started first and then your alarm. After power is supplied
(either battery or AC) ensure that no buttons are pressed for 10 minutes.
This will allow time for the projection alarm to communicate with the
remote sensor as well as receive the WWVB signal.
Note: When using the AC adaptor, plug into the projection alarm first
and then into the electrical outlet (this will help avoid pressing any
buttons inadvertently).
3) Wait 10 minutes for WWVB reception and remote temperature.
4) If there is no WWVB reception, manually set the time and date
(instructions in the Program Mode).
5) Program the settings.
6) Mount the WT-5442 in a suitable location, where WWVB and sensor
signals can be received.
7) Mount the sensor where remote temperature measurement is
desired (on the North side of a house for example).
Note: The remote sensor is weather resistant but not waterproof. High
humidity and mist will not damage the sensor but direct rain will. The
maximum range between the sensor and projection alarm is 80ft. open
air (no obstructions). Any resistance (i.e. walls, furniture, etc) between
the two will decrease the effective operating range.
8) The projector will activate and remain on if the alarm clock is plugged
in. If only batteries are used, the projector will only be activated when
a button is pressed.
9) See the "Features" section III. for instructions on projection direction,
etc.

DETAILED SET-UP GUIDE

I.

BATTERY INSTALLATION

A. REMOTE TEMPERATURE SENSOR
1. Remove the battery cover.
Observing the correct polarity,
install 2 AA batteries. The
batteries will fit tightly (to avoid
4