Quick Set-Up Guide; Detailed Set-Up Guide Battery Installation - La Crosse Technology WT-5442U Instruction Manual

variance in the quartz. However, the clock will adjust the quartz timing over the
course of several days to be very accurate; under 0.10 seconds per day.

QUICK SET-UP GUIDE

1) Insert two AA batteries into the remote transmitter.
2) Insert three AA batteries into the projection alarm and/or plug into
wall.
Note: When starting or restarting your projection alarm the remote
transmitter must be started first and then your alarm. After power is
supplied (either battery or AC) ensure that no buttons are pressed for 10
minutes. This will allow time for the projection alarm to communicate
with the remote transmitter as well as receive the WWVB signal.
Note: When using the AC adaptor, plug into the projection alarm first
and then into the electrical outlet (this will help avoid pressing any
buttons inadvertently).
3) Wait 10 minutes for WWVB reception and remote temperature.
4) If there is no WWVB reception, manually set the time and date
(instructions in the Program Mode).
5) Program the settings.
6) Mount the WT-5442 in a suitable location, where WWVB and
transmitter signals can be received.
7) Mount the transmitter where remote temperature measurement is
desired (on the North side of a house for example).
Note: The remote transmitter is weather resistant but not waterproof.
High humidity and mist will not damage the transmitter but direct rain will.
The maximum range between the transmitter and projection alarm is
80ft. open air (no obstructions). Any resistance (i.e. walls, furniture, etc)
between the two will decrease the effective operating range.
8) The projector will activate and remain on if the alarm clock is plugged
in. If only batteries are used, the projector will only be activated when
a button is pressed.
9) See the "Features" section III. for instructions on projection direction,
etc.
DETAILED SET-UP GUIDE
I. BATTERY INSTALLATION
A. REMOTE TEMPERATURE
TRANSMITTER
1. Remove the battery cover.
Observing the correct polarity,
install 2 AA batteries. The
4