Program Mode - La Crosse Technology WT-5442 Instruction Manual

start-up problems make sure that they do not spring free during
installation).
2. Replace the battery cover.
B. PROJECTION ALARM
1. Remove the battery
cover.
2. Observe the correct
polarity, and install 3 AA
batteries.
3. In addition or instead of
inserting batteries, the
AC adapter can be used. Simply plug the adapter into the receptacle
on the underneath of the alarm clock and then plug the adapter into
the outlet.
4. Replace the battery cover.
5. The projector will activate and remain on if the alarm clock is plugged
in. If only batteries are used, the projector will only be activated when
a button is pressed. The projection is a red light, not harmful under
normal usage, although care should be taken to not look directly into
the light.
Note: After power has been supplied (battery or AC) a tone will
sound, and the LCD (Liquid Crystal Display) will activate. The indoor
temperature and the remote temperature will be displayed (within
three to six minutes). Also, the time will appear as "-:--". The WWVB
search is automatically initiated, and a tower icon appears and
flashes with the time colon (no tower icon will appear if the WWVB is
too weak to be detected, which is typical during daylight hours and
the time display will remain on "-:--"). While the WWVB search is
being conducted various numbers will appear in the time display.
After 10 minutes, the Projection Alarm will either display the WWVB
time, or discontinue the search if the time is not found. If the search
is cancelled "-:--" will remain in the time LCD. The Projection Alarm
will conduct a WWVB search every hour until the first signal is found.
Once the WWVB time is found, a search is automatically conducted
nightly at midnight. If the signal is found at midnight, the tower icon
will remain, if not, another search will take place every hour (until
6:00 am) until the signal is found successfully. If no signal is found
during this period, the tower icon will not appear and the clock will
search again at 12:00 am the next night.
II.

PROGRAM MODE

To enter the Program Mode hold down the "SET" button for 1 second, until
the time zone ("-5" default) flashes in the lower left. The Program Mode
5