Table 4-5 Remote Node Network Layer Options Menu Fields - ZyXEL Communications Prestige 310 User Manual

The next table gives you instructions about configuring remote node network layer options.

Table 4-5 Remote Node Network Layer Options Menu Fields

FIELD
If your ISP did not assign you an explicit IP address, select Dynamic;
IP Address
Assignment otherwise select Static and enter the IP address & subnet mask in the
following fields.
If you have a Static IP Assignment, enter the IP address assigned to
Rem IP Address
the remote node.
If you have a Static IP Assignment, enter the subnet mask assigned
Rem IP Subnet
Mask to the remote node.
My WAN Addr Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the WAN
port of your Prestige.
Note that this is the address assigned to your local Prestige, not the
remote router.
Network Use the [SPACE BAR] to select either Full Feature, None or SUA
Address Only. See the NAT chapter for a full discussion on this feature.
Translation
Metric The metric represents the "cost" of transmission for routing purposes.
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. Enter a number that
approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Private This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
Press the [SPACE BAR] to select the RIP direction. Options are:
RIP
Both, None, In Only, Out Only or None.
section for more information on RIP. The default for RIP on the
WAN side is None. It is recommended that you do not change this
setting.
Remote Node Setup
Prestige 310 Broadband Sharing Gateway
DESCRIPTION
Please see the RIP Setup
EXAMPLE
Dynamic
192.168.1.1
255.255.255.0
SUA Only
1 to 15
Yes
None
(default)
4-9