Manual Mode Linearization - Teledyne 7320 Operating Instructions Manual

4 Operation
UP/DOWN to select and Enter
has been accomplished satisfactorily.
The leftmost digit (under
tored. Use the UP/DOWN keys to select the successive points.
The value is the input to the linearizer. It is the simulated output of
the analyzer. You do not need to actually flow gas.
The value is the output of the linearizer. It should be the ACTU-
AL concentration of the span gas being simulated.
If the
ed. ESCAPE to return to the previous screen. Select and Enter
Calibration Mode screen.
There are two ways to linearize:
requires as many calibration gases as there will be correction points along the
curve. The user decides on the number of points, based on the precision re-
quired.
The manual mode only requires entering the values for each correction
point into the microprocessor via the front panel buttons. Again, the number of
points required is determined by the user.
Note: Before performing section 4.8.2 or 4.8.2.3, you must check to
ensure that your calibration gases or points are between low
end and high end of the range setup. All correction points
must be between the Zero and the Span concentration. Do not
enter the Zero and Span points as part of the correction

4.8.2.2 Manual Mode Linearization

To linearize manually, you must have previous knowledge of the nonlinear
thermal-conductivity characteristics of your gases. You enter the value of the
differential between the actual concentration and the apparent concentration
(analyzer output). Analytical Instruments has tabular data of this type for a large
number of gases, which it makes available to customers on request. See Appen-
dix for ordering information. To enter data:
4-30
) is the number of the data point being moni-
value shown is not correct, the linearization must be correct-
Teledyne Analytical Instruments
to check whether the linearization
and : The auto mode
Model 7320
to