Rear Panel Connections-Analysis Unit; Figure 3-8: Analysis Unit Rear Panel - Teledyne 3010MA Operating Instructions Manual

Part 1 Control Unit
The Analysis Unit is installed adjacent to the Control Unit usually on
the same panel. Refer to Section 3.2 for mounting instructions. An outline
drawing D73635, is included in the Drawings section in the rear of this
manual which contains a panel cutout diagram.
3.5 Rear Panel Connections—Analysis Unit
The Rear Panel of the Analysis Unit is shown in Figure 3-8. The
following connections to the Analysis Unit are made at the rear panel:
Gas connections
Sample In
Sample Vent
Pressure Vent (pressure compensation line to Control Unit)
Electrical
Signal Output
Heater Power

Figure 3-8: Analysis Unit Rear Panel

Teledyne Analytical Instruments
Model 3010MA
38