Installing The Logset; Installing The Ember Material; Operation - Montigo M40DV-CR Installation Operation & Maintenance

Installation
Installing the Logs and Embers
Bottom Logs
The M40DV-CR/CL is supplied with five (5) fibre logs. The two large
bottom logs (logs "A" and "B") are mounted on the burner grate by
placing them into the slots.
Top Logs
Place logs "C" and "D" into their mating positions on the large logs as
shown in Figure 16a below. Log "E" is mounted on top of logs "C" and
"D" as shown in Figure 23b.
WARNiNG: if logs are not placed properly, excessive
sooting will result.
Log 'D'
Figure 23a. Log Installation.
Ember
material
Figure 23b. Completed Installation.

Installing the Ember Material

The ember material is supplied in two packages. Place the material
evenly along both ember burner tubes, next to logs 'A' and 'B'. Refer
to figure 23b. Ensure that the burner carries over properly after plac-
ing the embers.
CAUTION!
Fireplace gas control must be in the "OFF" position and pilot

and main burners extinguished when cleaning appliance with
a vacuum.
Doors can get very hot. Handle only when cool.

P/N XG0206
Log 'C'
Log 'B'
Log 'A'
Log 'E'
Ember material
M40DV-CR/CL Corner Gas Fireplace

Operation

Lighting Instructions
See Pages 15-16.
Burner Adjustment
The M40DV-CR/CL is equipped with an adjustable burner, allowing
you to raise or lower the flames. To adjust the flames, locate the black
knob marked 'Hi-Lo', in the centre of the gas control valve (See Figure
24). The front burners are not adjustable.
To raise the flame height, turn the black knob (located behind the

lower trim) counterclockwise.
To lower the flame height, turn clockwise.

Figure 24. 'Hi-Lo' Adjustment on the M40DV-CR/CL's gas valve.
Note: M40DV-CR/CL-I (electronic ignition) or M40DV-CR/CL-
MH (mobile home) models do not feature hi/lo adjust-
ment.
For electronic ignition (HSI) models see figure 21, for
mobile home approved models see Appendix B.
WARNING!
Do not attempt to clean glass when hot.
Do not clean glass with abrasive materials as any glass etch-
ing may cause premature glass failure.
CAUTION!
Cautions:
DO NOT OPERATE THIS FIREPLACE WITH-
OUT THE GLASS DOOR OR WITH A BROKEN
GLASS DOOR.
Page 15