Introduction - Montigo M40DV-CR Installation Operation & Maintenance

Introduction

The M40DV-CR/CL is a direct-vented, 2-sided Gas Fireplace with
an adjustable burner. It can be converted to both a top vent or rear
vent unit, and it is available in two models:
Model M40DV-CR/CL (continuous pilot)

Model M40DV-CR/CL-I (intermittent pilot)

Model M40DV-CR/CL-F (SIT Electronic)

Model M40DV-CR/CL-MH (mobile home)

For Mobile Home Approved Models See Appendix B
This manual covers installation, operation and maintenance. Light-
ing, operation and care of this fireplace can be easily performed by
the homeowner. However, all installation and service work should be
performed by a qualified or licensed installer, plumber, or gasfitter
who is qualified or licensed by the state, province, region, or govern-
ing body in which the appliance is being installed.
This manual covers both models and unless otherwise specified, the
designation M40DV-CR/CL refers to both models. Sections which are
specific to a particular model are marked with a
plus the appropriate model number.
The M40DV-CR/CL is rated for:
Natural Gas at 30,000 BTU/H (8.79 Kilowatts) max. input, and

24,000 BTU/H (7.03 Kilowatts) min. input.
Propane at 30,000 BTU/H (8.79 Kilowatts) max. input, and

24,000 BTU/H (7.03 Kilowatts) min. input.
The Montigo warranty will be voided by, and Montigo disclaims any
responsibility for, the following actions:
Modification of the fireplace and/or components including Direct-

Vent assembly or glass doors.
 Use of any component part not manufactured or approved by
Montigo in combination with this Montigo fireplace system.
 Installation other than as instructed in this manual.
Consult your local Gas Inspection Branch on installation require-
ments for factory-built gas fireplaces. Installation & repairs should be
done by a qualified contractor.
Installations in Canada must conform to the current CAN/CGA
B-149.1 and .2 Gas Installation Code and local regulations. This fire-
place's fans must be electrically grounded in accordance with CSA
C22.1 Canadian Electrical Code Part 1 and/or Local Codes.
Installations in the USA must conform to local codes, or in the ab-
sense of local codes to the National Fuel Gas Code, ANSI Z223.1-
1988. The fans must be grounded in accordance with local codes
or, in the absence of local codes, with the National Electrical Code,
See Appendix C for fireplace installations
ANSI/NFPA 70-1987.
within the State of Massachusetts
P/N XG0206
symbol,
.
M40DV-CR/CL Corner Gas Fireplace
CAUTION!
Due to its high operating temperatures, the appliance
should be located out of traffic & away from furniture and
draperies.
Children and adults should be alerted to the hazards

of the high surface temperature, which could cause
burns or clothing ignition.
Young children should be carefully supervised when

they are in the same room as the appliance.
Clothing or other flammable materials should not be

placed on or near the appliance.
Page 3