Appendix
Calibration Data
The following data, along with any Addenda that may be included in
the front part of this manual, pertain to your specific Thermal Conductivity
Analyzer.
Calibration data for Model:
Non-measured components:
Reference and Zero Gas:
Note: If the zero gas contains a known (or equivalent) impurity,
the zero control should be set so that the analyzer indi-
cates the impurity during the standardization procedure.
Selected Resistor Values:
Alarm Strapping:
A-2
______________________
Serial Number:
______________________
Range:
______________________
______________________
Output Signal:
______________________
______________________
Span Gas:
______________________
______________________
______________________
______________________
______________________
______________________
Zero Setting:
______________________
Span Setting:
______________________
Teledyne Analytical Instruments
Model 235