Mounting - GBC Arctic Titan 165 Manual

Before mounting it is recommended that you trim your finished print. Your print should
now have an overlaminate film on the front side and mounting film on the reverse. In this
process you will be using the adhesive in the mounting film to adhere to a board. The maximum
thickness board that you can run on the Arctic Titan is ½", (1.27cm).
1. Remove film as in step 1 – 6 of the Film Loading and Threading section.
2. Place the mounting board on a flat surface.
3. Position the print face down on the board
4. Peel back the leading edge of the liner about 1 or 2", (3 to 5cm) and put a slight crease
into the liner.
5. Flip the print over onto the board, allowing the print to rest on the crease that you
created.
6. Line up the print to where you want to mount it on the board.
7. Place your hands about 4 to 5", (10 to 134cm) from the leading edge of the print and tack
the center of the adhesive to the board.
8. Run your fingers along the edge from the center out. The print is now positioned on the
board.
9. Remove the pressure plate from the Arctic Titan.
10. Place the board in the center of the feed tray against the nip rollers.
Page 14
Arctic Titan 165 Operation and Maintenance Manual

Mounting

© GBC Films Group October 2000