LAMINATOR UNTIL YOU HAVE COMPLETELY READ THESE INSTRUCTIONS. MAINTAIN THESE INSTRUCTIONS IN A CONVENIENT LOCATION FOR FUTURE REFERENCE. ABC Office Important Safeguards General safeguards • Use this laminator only for its intended purposes as according to the specifications outlined in the operating instructions.
Caring for the Ultima 35 EZload The only maintenance required by the operator is to periodically clean the heat shoes. The following procedure will help keep the heat shoes free of adhesive that has been deposited along the edge of the laminating film.
The lower Idler Bar is attached to the Feed Table to facilitate easy film loading. ABC Office I. NIP ROLLERS: (figure 3b) The Nip Rollers are located behind the heat shoes. The nip point is where the heated film is compressed and pulled through the laminator.
The film cutter may be used to separate the laminated items. Position the cutter on either side of the laminator, depress the cutter handle while sliding the cutter across the film. ABC Office ) to the ‘RUN’ ) to the 800.658.8788...
When the film has cleared the heat shoes, move the RUN / STOP / REVERSE SWITCH ( ) to the ‘STOP’ ( Thread the film per section Film Loading and Threading. ABC Office Specifications Operating Speed Dimensions (W x L x H)
Defects due to misuse or use for inappropriate purposes are not covered under the guarantee. Proof of date of purchase will be required. Register this product online at www.gbc.com ABC Office POSSIBLE CAUSE Standby switch on control panel is not activated.