Low Battery Level; Pairing A Dect Cordless Accessory With A Dect Cordless Module; Pairing A Bluetooth Accessory With A Bluetooth Module - Mitel 5360 User Manual

Cordless Devices
Pairing the Cordless Module and Devices
Before using the cordless handset or headset, each device must establish communication with
the cordless module using a procedure called pairing.
NOTES

Pairing a DECT Cordless Accessory with a DECT Cordless Module

To pair a DECT cordless device:
1.
2.
3.
4.
5.

Pairing a Bluetooth Accessory with a Bluetooth Module

NOTES
To pair a Bluetooth accessory:
1.
2.
3.
Page 82
An IP phone can have only one cordless handset and one cordless headset.
A cordless handset or headset can be paired with only one IP phone at a time.
Pairing a new cordless handset or headset with the IP phone overwrites the
configuration of any previous handset or headset.
Pairing cannot be performed when the cordless device is already in use.
Ensure that the battery of the cordless device to be paired is at least partially charged.
Press and hold down the pairing button on the back of the cordless module
(see page 81) for five seconds to activate phone pairing mode. The LED on the cordless
module blinks. The Cordless Devices application opens on the IP phone and prompts
you to press the pairing button on the cordless device.
Press and hold down the hookswitch on the cordless handset or headset for five
seconds to activate the device pairing mode. The LED on the cordless device blinks.
After a moment, the Cordless Devices application displays information for the device to
be paired.
If the LED on the Cordless accessory does not start to blink after 10
seconds, the accessory requires charging or is still in factory battery saving
mode (handset only). Place the accessory on the charger and charge. The
NOTE
green LED starts to flash indicating that the accessory is charging. It could
take up to 60 minutes for the green LED to start flashing. Allow the
accessory to fully charge, approximately 3 hours.
Press Yes to confirm pairing. The Cordless Devices application confirms the pairing by
displaying the paired device name and its battery level indicator and the number of
devices paired.
Press Close to exit.
An IP phone can have one Bluetooth Handset and up to five Bluetooth headsets
(or up to six headsets if no handset is paired).
To pair a new Bluetooth Handset, you must first unpair the existing Bluetooth
Handset.
Pairing cannot be performed when a Bluetooth device is already in use.
Ensure that the battery of the Bluetooth device to be paired is at least partially charged.
Press and hold the pairing button on the back of the Bluetooth Module for 5 seconds to
activate phone pairing mode. The LED on the Bluetooth Module blinks. The Cordless
Devices application opens on the phone and prompts you to place the accessory in
pairing mode.
For Mitel Bluetooth Handsets: Press and hold the hookswitch on the side of the
Bluetooth Handset (see page 81) for 5 seconds to activate accessory pairing mode. The
Mitel ® 5360 IP Phone User Guide – , April 2013