F
1
Cover Plate
Louvers
• Fit the cover plate over the opening above the louvers in
the front of the vehicle body.
• Insert two # 8 x
1
/
" screws through the cover plate and
2
into the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
2
Rear Wheel
Gearbox
• Position the vehicle body upside down. Make sure that
the tabs on the gearboxes rest against the rear axle
support bars so the gearboxes and motors do not
hang down.
• Slide two
7
/
" washers onto one of the rear axles.
16
• Slide a rear wheel, driver side first, onto the rear axle.
• Fit the teeth on the gearbox into the notches in the driver.
Assembly
Vehicle
Body
Driver
Rear Axle
7
/
" Washers
16
Teeth
Tabs
Rear Axle
Support Bar
9
3
• Fit a hubcap on the rear axle and slide it into the center
of the rear wheel.
4
• Slide a hex bushing onto the rear axle. The ring side of
the hex bushing should face out.
• Press firmly to fit all but the ring on the end of the hex
bushing into the rear wheel.
Rear Axle
Hubcap
Rear Axle
Hex
Bushing
Ring Side