Table of Contents
Advertisement
Quick Links
Product features and decoration may vary from the picture above.
Owner's Manual
with Assembly Instructions
Please read this manual and save it with your original sales receipt.
For Model 78477
Tools needed for assembly: Phillips Screwdriver, Hammer, and Safety Scissors (not included).
Use only with a Power Wheels
12 Volt Battery and Power Wheels
Type "12V" Charger (both included).
®
®
Requires four LR6 "AA" alkaline batteries (not included) for Lights and Siren.
Advertisement
Table of Contents
Related Manuals for Fisher-Price BARBIE 78477
Summary of Contents for Fisher-Price BARBIE 78477
- Page 1 Product features and decoration may vary from the picture above. Owner’s Manual with Assembly Instructions Please read this manual and save it with your original sales receipt. For Model 78477 Tools needed for assembly: Phillips Screwdriver, Hammer, and Safety Scissors (not included). Use only with a Power Wheels 12 Volt Battery and Power Wheels Type "12V"...
-
Page 2: Table Of Contents
Important Information ..............2 Warnings . -
Page 3: Warnings
• Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help in assembly of the vehicle. -
Page 4: Parts
• If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. - Page 5 Parts Dash Knob – 2 Rear Bumper Seat Brushguard Spacer Tube – 2 Cap Nut – 3* Knob Plate Key Assembly Dash Steering Column Steering Wheel Cap Steering Wheel Hood Latch – 2 Hood Brush Guard Not Shown: Label Sheet, Literature Bag...
- Page 6 Parts Windshield Hinge Pin – 2 Windshield Bracket – 2 Windshield Frame - Front Windshield Frame - Back Water Jug Water Jug Holder Sport Bar Sport Bar Bracket Set Sport Bar Support - 2 Right Sidepipe Canopy Left Sidepipe...
- Page 7 Parts #6 Washer - 2 Lights and Siren Microphone #6 x " Screw – 2 These components are found in the Lights and Siren Box #10 x " Screw – 2 #8 x4" Screw – 2 #8 x 1 " Screw – 10 #8 x "...
-
Page 8: Parts Diagram
Parts Diagram... - Page 9 Part Vehicle Body Steering Column .354 Cap Nut Hood Latch 12 Volt Battery Battery Retainer #8 x 4" Screw Taillight Lens Taillight Housing #8 x 1" Screw Gas Cap Dash #10 x 1" Screw #10 x " Screw Windshield Hinge Pin Knob Plate Dash Knob Microphone...
-
Page 10: Battery Charging
WARNING • The battery must be handled by adults only. The battery is heavy and contains sulfuric acid (electrolyte). Dropping the battery could result in serious injury. • Never allow children to charge the battery. Battery charging must be done by adults only. - Page 11 Important Notes • Your new battery must be charged for at least 18 hours before you use it in your vehicle for the first time. • You do not need to remove the battery from your vehicle to recharge it. •...
-
Page 12: Assembly
Do not omit any steps. Please set aside at least 45 minutes for assembly. Left Sidepipe Screw Pegs Vehicle Body • Turn the vehicle body upside down. • Fit the left sidepipe under the left (driver) side of the vehicle body. •... - Page 13 Dash • Insert the end of the microphone cord though the hole under the dash and into the hood area. • Place the microphone in the dash pocket. 60 70 RPM x 1000 TEMP ® IGNITION • Apply labels to the dash as indicated in the illustration. Steering Column Bottom View...
- Page 14 Steering Wheel • Fit the steering wheel cap into the center of the steering wheel with the screw holes aligned. • Insert two #8 x 1" screws as shown. • Tighten the screws with a Phillips screwdriver. Do not over-tighten. Wide Tab Lens Guard...
- Page 15 Spacer Tube • Fit a spacer tube between the grille and the back of the brush guard, as shown. • Insert a #8 x 4" screw through the brush guard and spacer tube and into the hole in the grille. •...
- Page 16 Hinge Pin Windshield Frame - Front Half • Rotate the front half of the windshield frame down so it lays flat on the vehicle body. • Working from the center of the vehicle, insert a hinge pin through the holes in the windshield frame and the holes in the windshield bracket, as shown.
- Page 17 Lights and Siren Lights and Siren Cord • Insert the lights and siren cord through the hole in the center of the hood. • Fit the lights and siren to the top of the hood. Make sure the speaker faces the front of the hood. •...
- Page 18 Short Seat T-Loop (Pull through slot) Belt Strap T-Loops Seat • Turn the seat upside down. • Insert the fastener end of a short seat belt strap through the slot near the outer edge of the seat. Make sure the side of the seat belt with the fastener faces the outer edge of the seat.
- Page 19 Canopy Sleeves Canopy Sport Bar • Position the sport bar on its side so that the sport bar ends curve away from you. • Position the canopy opposite the sport bar with the netting facing away from you. • Slide the four canopy sleeves onto the sport bar. Sport Bar •...
- Page 20 Rack - Back Half Sport Bar • Position the sport bar upright, as shown. • Fit and hold the front and back halves of the KC rack against the sport bar. Make sure the two KC rack halves are aligned, and that the screw holes in the light rack are aligned with the screw holes in the canopy and the sport bar.
- Page 21 Taillight Lens Rear Bumper Light Plate Taillight Housing • Using safety scissors, remove the taillight lenses and the taillight housings from the plastic connectors. Dispose of the plastic connectors. • Face the rear of the vehicle. • Fit a taillight lens inside a taillight housing. •...
-
Page 22: Label Decoration
Proper label application will help to keep the labels looking their best! When applying labels, keep the following guidelines in mind: • Wash your hands before applying the labels. • Before applying the labels, wipe the surface of the vehicle with a clean, dry cloth to remove any dust or oils. •... -
Page 23: Battery Installation
Important Note: Use only a Power Wheels Use of any other battery will damage your vehicle. Make sure that you charge the battery for at least 18 hours using the enclosed Power Wheels ® 12 volt charger before operating your vehicle for the first time. Charge the battery for at least 14 hours after each use of the vehicle. -
Page 24: Battery Care And Disposal
Battery Installation Hood Hood Latch • Lower the hood. • Lift the hood latches and fit the latch pegs onto the hood to close it. Battery Care and Disposal Disposal • Your Power Wheels ® battery is a sealed lead-acid battery. -
Page 25: Rules For Safe Driving
WARNING • Adult supervision is required. Children do not have the judgement necessary to avoid many accidents. Be sure that children operating this vehicle can do so safely and that they are supervised at all times. • Never use near steps, driveways, steep inclines, roadways, alleys, swimming pool areas or other bodies of water. -
Page 26: How To Operate Your Vehicle
Beginner Use - Low Speed Drive As assembled, your vehicle is ready to roll in low speed mph, maximum). It has been pre-set so it will only operate in low speed. After your child has mastered the basic skills of driving and understands the rules for safe driving, it’s time to disconnect the high speed lock-out to allow the vehicle to operate in low or high speed. -
Page 27: Caring For Your Vehicle
How to Operate Your Vehicle Advanced Use - High Speed Drive Disconnecting the High Speed Lock-Out Shifter Lock-Out Screw • Before you disconnect the high speed lock-out, make sure your child knows how to steer, how to start and stop the vehicle and knows the rules for safe driving. When the high speed lock-out is disconnected, the vehicle can be driven forward in low speed (2 maximum) or high speed (5 mph, maximum). -
Page 28: Problems And Solutions Guide
Problems and Solutions Guide IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, please contact Power Wheels free at 1-800-348-0751 between 8 AM and 5 PM (EST) Monday through Friday. Or, contact your local Power Wheels authorized service center. - Page 29 Problems and Solutions Guide Problem Vehicle was running but Loose wire or loose connectors suddenly stopped Tripped thermal fuse Short run time (Less than Undercharged battery 1 - 3 hours per charge) Overcharged battery Battery is old and will not accept full charge Tripped thermal fuse Possible Cause...
- Page 30 Problems and Solutions Guide Problem Vehicle runs sluggishly Undercharged battery Battery needs charging Battery is old and will not accept full charge Vehicle is overloaded Driving conditions are too stressful Vehicle runs in low speed, but High speed lock-out not disconnected does not run in high speed (Please Note: The vehicle is designed to operate in low...
- Page 31 Problems and Solutions Guide Problem When the foot pedal is pressed, Loose wire or connector the vehicle won’t run without a push “Dead Spot” on motor Loud clacking or grinding Broken gears noise from a motor-gearbox Lights and siren not working Improperly installed batteries Dead batteries Charger gets warm during use...
-
Page 32: N Statement Of Limited Warranty
Bumper-to-Bumper* Limited Warranty *One year limited warranty from the date of purchase on the Power Wheels Six month limited warranty on the 12 volt battery. For the original purchaser, this one year limited warranty covers the Power Wheels ® ride-on vehicle (purchased from Power Wheels ®... - Page 33 DELAWARE SELBYVILLE - Ahern & Son, Inc., #2 S. Dupont Hwy Rt. 2, 19975, (302) 436-4100 WILMINGTON - Lyons Hardware Do-It Center, 2021 Kirkwood Highway, 19805, (302) 995-1260 MEXICO - S.E.G.E.S.A., Calz De Tlalpan 1172-A, CP3540 FLORIDA ATLANTIC BEACH - First Coast Repair, 25 Seminole Road, 32233, (904) 246-4616 CAPE CORAL - Family Hardware #0827 Do-It Express, 33904, (941) 542-6365...
- Page 34 MICHIGAN ALMONT - Almont Do It Center #421, 4545 Van Dyke, 48003, (810) 798-8922 BAY CITY - Bay Vac & Pedal, 805 Columbus Ave., 48708, (517) 892-7516 BRIGHTON - Complete Battery Source, 8023 W. Grand River, 48116, (810) 220-1050 DAVISON - Gill-Roy’s Hardware, 8405 East Davison, 48423, (810) 653-2288 DEARBORN - McNichols Electric Service, 1836 Grindley Park, 48124, (313) 563-7550...
- Page 35 OKLAHOMA MC ALESTER - Quality Upholstery, 803 E. Gene Stipe Blvd., 74501, (918) 423-4747 OKLAHOMA CITY - Brand Appliance Repair, Co., 538 N. Pennsylvania Avenue, 73107, (405) 235-0583 OKLAHOMA CITY - Appliance Services By CK, 101 East Madison, 73105, (405) 5258862 OKLAHOMA CITY - Oklahoma Service Center, 1940 North May Avenue, 73107, (405) 946-9841 TULSA - H.L.
- Page 36 JEEP and the Jeep grille design are registered trademarks of DaimlerChrysler Corporation and are used under license. ©DaimlerChrysler Corporation Fisher-Price, Power Wheels, Power Wheels by Fisher-Price and BARBIE are U.S. trademarks of Mattel, Inc. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14052.