Fisher-Price POWER WHEELS 78475 Owner's Manual & Assembly Instructions page 11

9
Front Axle
• Slide a hex bushing onto the front axle. The ring side of
the hex bushing should face out.
• Press firmly to fit all but the ring on the end of the hex
bushing into the front wheel.
10
• Fit a cap nut on the end of the front axle.
• Tap the cap nut with a hammer to secure it on the end of
the front axle.
• Pull on the wheel to make sure the cap nut is securely
fastened.
• Repeat this procedure to assemble the other front wheel
to the other front axle.
• Set the vehicle body aside.
Assembly
11
Hex Bushing
Ring Side
Note: For packaging reasons, the console/headlight has
been pre-assembled at the factory. You will need to disassem-
ble the console/headlight to assemble it to the handlebar.
• Loosen and remove the #6 x
• Loosen and remove the two #8 x 1" screws in the upper
• Set the screws, upper console, lower console and
12
Cap Nut
• Position the handlebar with the grip area up.
• Fit the neck against the bottom of the handlebar, with the
• Position the handlebar so the grip area points away
• While holding the neck to the handlebar, fit the lower
• Insert two 2" screws up through the neck, handlebar and
• Tighten each screw with a slotted screwdriver. Do not
11
#8 x 1"
Screws
Lower Console
#6 x 1 / " Screw
2
with a Phillips screwdriver. Remove the headlight by first
pulling the bottom out slightly and then pushing the
headlight up.
console with a Phillips screwdriver.
headlight aside for assembly steps 12-20.
Lower Console
Open End
Grip Area Up
and Pointed
Away
holes in the handlebar and neck aligned.
from you.
console, with the open end toward you, onto the handlebar.
into the lower console.
over-tighten.
Upper Console
Headlight
1 / " screw in the headlight
2
Grip Area Up
and Pointed
Away
Handlebar
Neck