Table of Contents
Advertisement
74547a-0920.qrk
6/29/01
N
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions
Guide below. If you still experience a problem, please contact Power Wheels
toll-free at 1-800-348-0751 between 8 AM and 6 PM (EST) Monday through Friday. Or, contact your
local Power Wheels
Authorized Service Center list beginning on page 24.
Problem
Vehicle does not run
8:20 AM
Page 20
Problems and Solutions Guide
authorized service center. For the location nearest you, please refer to the
®
Possible Cause
Undercharged battery
Charger is not working
Wrong type or improperly installed fuse
Blown fuse
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Charge the battery. A new battery should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for
at least 14 hours after each use. Never charge the battery
longer than 30 hours.
Check all connectors. Make sure the battery connector is
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless
you have a volt meter. If you suspect there is a problem with
your charger, contact your local Power Wheels
service center. They can test your charger for you.
Make sure that the battery has a properly installed
Power Wheels
25 amp fuse before charging.
®
Do not substitute parts.
Make sure that the fuse in the battery is in good
condition. Replace a blown fuse with a Power Wheels
25 amp fuse. Do not substitute parts.
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness
connector, and that there are no loose wires around
the motors.
If your battery is old or if you have not followed Battery
Care instructions, your battery may be dead. If you are
unsure whether or not the battery is dead, you can have
it tested at your local Power Wheels
service center.
The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact your local Power Wheels
authorized service center for diagnosis and repair.
Contact your local Power Wheels
for diagnosis and repair.
20
Consumer Relations,
®
Solution
®
authorized
®
®
authorized
®
®
authorized service center
Advertisement
Table of Contents
