Summary of Contents for Fisher-Price 3-in-1 Construction Rider
Page 1
3-in-1 Construction Rider Model Number: 74532 Keep this instruction sheet for future reference, as it contains important information. Adult assembly is required. Requires three “AA” (LR6) alkaline batteries (not included). Tools needed for assembly: Hammer and Phillips screwdriver (not included).
Page 2
Parts IMPORTANT! • Please save all packaging material until assembly is complete to ensure that no parts are discarded. • If you are missing a part, please call toll-free 1-800-432-KIDS, rather than return this product to the store. • Please wipe each part with a clean, dry cloth before assembly. * Some parts are stored inside the frame to prevent them from damaging the frame during shipment.
Assembly Warning and Caution Frame WARNING Remove Grill Axle • Direct adult supervision required. • Never use near steps, sloped driveways, Remove hills, roadways, alleys, swimming pools or Tape other bodies of water. Remove • Always wear shoes. Screw and Washer •...
Page 4
Assembly Frame Rear Axle Rear Axle Cap Nut • Slide the rear axle through the six holes/slots in the rear end of the frame. • Place a cap nut on a flat surface, inside up. • Fit the end of the rear axle into the cap nut. X Marking Long Side...
Page 5
Assembly Barrel Side Barrel Side Round Bushing Round Bushing Round Bushing Cap Nut Round Bushing Front Axle Cap Nut • Fit a round bushing, barrel side first, onto the rear axle. • Fit a cap nut onto the end of the rear axle and tap the cap •...
Page 6
Assembly Cap Nut Grill Axle Left Front Axle B Cap Nut • Place a cap nut on the end of the left front axle B. Tap the • Place a cap nut on a flat surface, inside up. cap nut with a hammer to secure the cap nut on the end of the left front axle B.
Page 7
Assembly Steering Wheel Retainer Dashboard Cap Nut Grill Axle • Turn the dashboard face down. • Fit the steering wheel retainer to the dashboard. • Insert two #8 x " screws through the steering wheel retainer and into the dashboard. Tighten the screws with •...
Page 8
Assembly Small Washer Shifter Dashboard Steering Wheel Dashboard Hole Hole • Insert and "snap" the shifter into the hole in the dash- board, as shown. • Fit the steering wheel into the hole in the dashboard, as shown. • Fit the small washer onto the peg inside the steering wheel. •...
Page 9
Assembly Battery Compartment Door Steering Wheel Battery Compartment Sound Box Sound Box 1.5V x 3 “AA” (LR6) • Place the sound box, speaker side down, into the center of SHOWN ACTUAL SIZE the steering wheel. • Loosen the screw in the sound box battery compart- ment door using a Phillips screwdriver.
Label Decoration Proper label application will help to keep the labels looking their best. • Wash your hands before applying the labels. • Make sure the areas where the labels will be applied are clean and dry. Wipe this toy with a clean, soft, dry cloth to remove any dust or oils.
Let's Go to Work! Push Mode Wagon/Pull Mode Shovel Shovel Slot Slot Rear Bumper Grill Shovel Shovel Grill Rear Bumper • Insert the shovel into • Insert the shovel into the slot in the rear the slot in the grill. bumper of the vehicle.
® Consumer Relations, toll-free at 1-800-432-KIDS, 8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using TTY/TDD equipment, please call 1-800-382-7470. Or, write to: Fisher-Price ® Consumer Relations, 636 Girard Avenue, East Aurora, New York 14052. For other countries, outside the United States: Canada: call 1-800-567-7724, or write to: Mattel Canada Inc, 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.