Problems And Solutions Guide - Fisher-Price POWER WHEELS ARCTIC CAT L2170 Owner's Manual

IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still
experience a problem, please contact Power Wheels
Monday through Friday and 11 AM - 5 PM (EST) Saturday. Or, contact your local Power Wheels
location nearest you, please visit us on-line at www.powerwheels.com, or call 1-800-348-0751.
PROBLEM
Vehicle does not run
PROBLEMS AND SOLUTIONS
® Consumer Relations, toll-free at 1-800-348-0751 between 9 AM - 7 PM (EST)
POSSIBLE CAUSE
Undercharged battery
Charger is not working
Tripped thermal fuse
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Charge the battery. A new battery should have been charged for
at least 18 hours before using the vehicle for the first time. After
first-time use, recharge the battery for at least 14 hours after each
use. Never charge the battery longer than 30 hours.
Check all connectors. Make sure the charger connector is plugged
into the battery, and that the charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless you
have a volt meter. If you suspect there is a problem with your
charger, contact your local Power Wheels
center. They can test your charger for you.
The built-in thermal fuse may "trip" and shut down operation of
the vehicle if the vehicle is overloaded or the driving conditions
too severe. Once a fuse has "tripped", remove your foot from the
pedal and wait approximately 25 seconds before operating the
vehicle again. To avoid repeated automatic shutdowns, do not
overload the vehicle by exceeding the 130 lbs. (59 kg) maximum
weight capacity or by towing anything behind the vehicle. Do not
drive up hills or run into fixed objects, which can cause the wheels
to stop spinning while power is still being supplied to the motors. If
a thermal fuse continually trips, contact your local Power Wheels
authorized service center.
Check all wires and connectors. Make sure the motor harness
connector is plugged into the battery, and that there are no loose
wires around the motors.
If your battery is old or if you have not followed Battery Care
instructions, your battery may be dead. If you are unsure whether
or not the battery is dead, you can have it tested at your local
®
Power Wheels authorized service center.
The electrical switches can become corroded due to exposure to
water or moisture, or can jam due to loose dirt, sand or gravel.
Contact your local Power Wheels
diagnosis and repair.
Contact your local Power Wheels
diagnosis and repair.
20
® authorized service center. For the
SOLUTION
®
authorized service
®
authorized service center for
®
authorized service center for
L2170a-0922
®