Assembly - Fisher-Price KAWASAKI NINJA POWER WHEELS 74750 Owner's Manual & Assembly Instructions

F
1
Cover Plate
• Fit the cover plate over the opening in the front of the
vehicle body.
• Insert two #8 x 1 / " screws (blunt silver) through the cover
2
plate and into the vehicle body.
2
Mudflap
Rear of
Vehicle
Body
• Tip up the back end of the vehicle.
• Using safety scissors, remove the mudflaps from the
plastic connector. Dispose of the plastic connector.
• Align the holes in a mudflap with the screwpegs under
one of the rear fenders. Make sure the textured side of
the mudflap faces toward the seat.
• Insert four #8 x 1 / " screws (blunt silver) through the mud-
2
flap and into the screwpegs.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the other mudflap to
the other rear fender.
Do not omit any steps. Please set aside at least
45 minutes for assembly.
Vehicle
Body
Rear Fender
(Underside)

Assembly

3
• Fit a rear wheel driver into a wheel.
• Insert a #10 x
the two screw holes in the rear wheel driver.
• Tighten the screw with a Phillips screwdriver to drive it
into the wheel.
• Repeat this procedure to assemble the other rear wheel
driver to another wheel.
4
Rear Wheel
• Position the vehicle body upside down. Make sure that
the tabs on the gearboxes rest against the rear axle
support bars so the gearboxes and motors do not
hang down.
• Slide two 7 /
16
• Slide a wheel with driver onto the rear axle, driver side
first.
• Fit the teeth on the gearbox into the notches in the driver.
10
1 / " screw (pointed silver) through either of
2
Driver
Rear Axle
Gearbox
Support Bar
" (large) washers onto one of the rear axles.
Rear Wheel
Driver
Rear Axle
7 / " (Large)
16
Washers
Teeth
Tabs