Table of Contents
Advertisement
F
Do not omit any steps. Please set aside at least 60 minutes for assembly.
1
Left Sidepipe
Screw Pegs
Vehicle
Body
• Turn the vehicle body upside down.
• Fit the left sidepipe under the left (driver) side of the
vehicle body.
3
• Insert two #8 x
/
" screws through the top of the left
4
sidepipe and into the screw pegs on the underside of
the vehicle body.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure to assemble the right sidepipe to
the right side of the vehicle body.
2
Tab
• Turn the vehicle body upright.
• Gently bend the tab on one of the sidepipes under the
vehicle body.
3
• Insert a #8 x
/
" screw through the hole in the vehicle
4
body floor and into the tab.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat this procedure on the other side of the
vehicle body.
Assembly
Rear of Vehicle
Rear of Vehicle
11
3
2
1
Tab
1
• Position the dash on the vehicle body. Make sure the
holes in the dash tabs align with the holes in the vehicle
body and that the channel cover is captured by the dash.
• Insert two #10 x 1" screws through the holes towards the
rear of the dash (closest to the hood area) and into the
vehicle body
1
.
• Insert two #10 x
/
" screws through the holes towards the
1
2
front of the dash (closest to the passenger compartment)
and into the vehicle body
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
4
Dash
Wires
• Identify the wires which exit from the end of the channel
cover. Identify the two wires that do not have large plastic
connectors at the end.
• Route the two wires through the hole in the dash wall.
Dash
1
Channel
Cover
2
2
.
Channel
Hole
Cover
2
Advertisement
Table of Contents
