Table of Contents
Advertisement
20
Windshield Frame – Back Half
Slots
Windshield Frame –
Front Half
• Fit the back half of the windshield frame onto the front
half of the windshield frame. Make sure the slots at the
bottom of the two windshield frame halves are aligned.
• Insert ten #8 x 1
1
/
" screws into the back half of the
4
windshield frame.
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Helpful Hint! Squeeze the two windshield halves together
while tightening the screws.
• Lift the assembled windshield to the raised position.
21
Hood Prop Base
• With the lip on the hood prop base facing down, align
the hole in the hood prop base with the hole in the
vehicle body near the battery compartment. The hood
prop base should lay flat on the vehicle body.
• Insert a #8 x
3
/
" screw through the hole in the hood
4
prop base. Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
Assembly
22
• Gently squeeze the ends of the prop arm to fit them
under the arm retainers on the hood prop base.
• Release the ends of the prop arm under the retainers.
23
Spark Plug Wire
Spark
Plug
• Snap the tabs on the bottom of the air scoop into the
slots on the top of the engine housing.
• Fit the pretend spark plug wires onto the pretend
spark plugs.
16
Prop Arm
Prop Arm
Air Scoop
Engine
Housing
Advertisement
Table of Contents
