Fisher-Price BARBIE JEEP B2489 Owner's Manual & Assembly Instructions page 19

37
Tabs
Rear Bumper
Lower Rail
• Turn the vehicle upright. Face the rear of the vehicle.
• Fit the lower rail on the rear bumper over the rear
bumper supports.
• Gently bend the tabs at the bottom of the rear bumper
under the vehicle.
38
Taillight
Lens
Rear Bumper Light Plate
Taillight
Housing
• Using safety scissors, remove the taillight lenses and the
taillight housings from the plastic connectors. Dispose of
the plastic connectors.
• Face the rear of the vehicle.
• Fit a taillight lens inside a taillight housing.
• Position the taillight housing with lens against a rear
bumper light plate with the screw holes aligned.
• Insert two #8 x 1" screws through the taillight lens, rear
bumper light plate housing and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Repeat this procedure to attach the other taillight.
Assembly
Rear Bumper
Support
• Position the gas cap so that its tether points down.
• Snap the gas cap into the hole under the right taillight.
19
39
Bumper Tabs
• Lift the rear of the vehicle.
• Align the holes in the rear bumper tabs with the screw
pegs on the underside of the vehicle.
• Insert two #8 x 1" screws through the bumper tabs and
into the vehicle.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
• Lower the rear of the vehicle.
40
Rear
Bumper
Gas Cap Tether