Fisher-Price BARBIE JEEP B2489 Owner's Manual & Assembly Instructions page 17

Short Seat
28
Belt Strap
End
T-Loops
Slot
Seat
• Turn the seat upside down.
• Insert the fastener end of a short seat belt strap through
the slot near the outer edge of the seat. Make sure the
side of the seat belt with the fastener faces the outer edge
of the seat.
• Pull the short seat belt strap completely through the slot
until the last T-loop at the opposite end of the belt catches
against the slot. You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
29
T-Loop
Fastener End
• Insert each fastener end of the long seat belt strap
through a slot in the center of the seat. Make sure the
fasteners face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly through
the slots. Make sure to pull each T-loop through a slot.
• Turn the seat upright.
Assembly
T-Loop (Pull through slot)
Fastener End
Slot
Long Seat Belt Strap
30
Seat
Seat
Back
Tabs
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall
• Push down firmly on the edge of the seat above each
tab to snap the tabs into the slots
• Rotate the back of the seat down
back tabs into the slots in the vehicle body. Push down
firmly on the seat back.
31
• Insert a #8 x 1" screw into the rear of seat, as shown.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
32
Sport Bar
• Fit the ends of the sport bar into the sleeves on the canopy.
Note: Make sure the pocket on the canopy faces the rear of
the vehicle.
17
Tabs
2
PUSH
HERE
1
Slot
.
to snap the seat
Dash View
Canopy
Sleeves
.