Korg EXB-MOSS Manual page 38

Intensity (Cutoff Frequency Mod. EG Intensity)
Specifies the depth and direction of the control that
"EG (Cutoff Frequency Modulation EG)" will have on
the cutoff frequency. With positive (+) settings of this
parameter, the tone will become brighter when the
various EG levels rise into the + area (the setting of the
"Frequency" will be reached when the EG levels are at
0), and darker when the EG levels fall into the – area.
With negative (–) settings of this parameter, the tonal
change will take place in the opposite direction.
Resonance
This setting emphasizes the overtones in the region of
the "Frequency" to add character to the sound. Higher
values will produce a stronger effect. With high
settings of resonance, the output signal of the filter
may distort. If this occurs, reduce the "A Trim"
setting.
With the Dual BPF(A/B) filter type, the overtones in
the vicinity of each cutoff frequency will be affected
in the same way as by a Band Pass(A).
The effect of resonance
Low Pass
High Pass
Band Pass
Band Reject
Low resonance value
AMS (Alternate Modulation Source)
Selects a modulation source ( p.48 of this manual)
that will control the amount of resonance.
Intensity (Resonance AMS Intensity)
Specifies the depth and direction of the effect that
"AMS" will have on the amount of resonance.
3-1d: Filter B
These parameters will be available if Dual BPF (A/B)
was selected as the Type in "3–1b: Filter Type."
For details on each parameter, refer to "3–1c: Filter
A." The EG and AMS are set in "3–1c: Filter A.
3-2: Filter1 Mod. (Filter 1 Modulation)
[–99...+99]
[0...99]
3–2a: FilterA/B Keyboard Track
Keyboard tracking settings specify how the cutoff
frequency of filter 1 will be varied according to
keyboard position.
Filter A:
Key Low
Specifies the key at which Lower keyboard tracking
will begin.
Key High
Specifies the key at which Higher keyboard tracking
will begin.
Ramp Low
Specifies the depth and direction of cutoff frequency
High resonance value
change that will occur below the "Key Low."
With a setting of –50, the change will match the
[Off...MIDI:CC#83] change in pitch.
Ramp High
Specifies the depth and direction of cutoff frequency
[–99...+99] change that will occur above the "Key High."
With a setting of +50, the change will match the
change in pitch.
3–2a
3–2b
You can also input a value by playing a note
on the keyboard while you hold down the
[ENTER] key.
Cutoff
frequency
Ramp> 0
0
-50
-99
C-1 C4
[C-1...G9]
[C-1...G9]
[–99...+99]
[–99...+99]
+99
+50
0
Ramp<0
C9
39