Korg EXB-MOSS Manual page 36

2–4a: Pitch Bend
Specifies the width of pitch change that will occur
when the joystick is moved to left and right.
JS(+X) (Joystick Intensity +X)
Specifies the amount and direction of pitch change (in
semitone units) that will occur when the joystick is
moved to the right.
With positive (+) settings the pitch will rise, and with
negative (-) settings the pitch will fall. A setting of 12
will produce one octave of change.
Step (Joystick Step +X)
[Continuous, 1/8, 1/4, 1/2, 1...12]
Specifies how the pitch will change when the joystick
is moved to the right.
Continuous: Smooth change.
1/8: Change in 1/8 semitone steps.
1/4: Change in 1/4 semitone steps.
1/2: Change in 1/2 semitone steps.
1...12: Change in steps of the specified number of
semitones (up to 1 octave).
JS(–X) (Joystick Intensity –X)
Specifies the amount and direction of pitch change (in
semitone units) that will occur when the joystick is
moved to the left.
Step (Joystick Step –X)
[Continuous, 1/8, 1/4, 1/2, 1...12]
Specifies how the pitch will change when the joystick
is moved to the left.
Refer to Step (Joystick Step +X).
If the Step (Joystick Step +X) or Step (Joy-
stick Step –X) settings are greater than the
settings for JS (+X) and JS (–X), the pitch will
not change.
2–4b: Common Pitch Modulation
Creates time-varying changes in the pitch of all
oscillators (oscillators 1 and 2, and the sub oscillator).
AMS (Alternate Modulation Source)
Selects the modulation source ( p.48 of this manual)
that will control the pitch of all oscillators (oscillators
1 and 2, and the sub oscillator).
Intensity (Common Pitch AMS Intensity)
Specifies the depth and direction of the effect pro-
duced by AMS.
2–4c: Portamento
These settings specify how portamento will be
applied. (Portamento creates a smooth change in pitch
from one note to the next.)
[–60...+24]
Enable
Check this when you wish to use portamento.
Fingered
Check this when you want to apply portamento only
when a note is pressed while continuing to hold the
previous note.
Time
Specifies the portamento time. Higher values will
cause the pitch to change more slowly.
AMS (Alternate Modulation Source)
Selects a modulation source ( p.48 of this manual)
that will control "Time."
Intensity (Portamento Time AMS Intensity)
[–60...+24]
Specifies the dipth and direction in which the
portamento time will be controlled by the "AMS ."
[Off...MIDI:CC#83]
[–99...+99]
[0...99]
[Off...MIDI:CC#83]
[–99...+99]
37