Update procedure
You must use the USB bus to power the recorder during this
update procedure. Otherwise, an error message will be displayed
and you will be unable to update software.
If a power failure or similar accident occurs while loading the sys‐
tem, the MR‐2 may become inoperable. If this occurs, please con‐
tact Korg distributor.
1. Press the menu button, and in the menu list (MENU) screen, use the
controller buttons to select and confirm "SYSTEM."
The system setting (SYSTEM) screen will appear.
2. Use the controller buttons to select and confirm "SoftwareUpdate."
A dialog message of "Upgrading the system. Are you sure?" will
appear in the screen.
3. Use the controller buttons to select and confirm "Yes."
The screen will indicate "SoftwareUpdate: Working..." and the sys‐
tem will be loaded.
When the system has finished loading, the display will indicate
"Software Update. Completed."
4. Press the Confirmation button (the center controller button); the
MR‐2 will shut down and the power will turn off.
5. Slide the power button to turn on the power; the MR‐2 will start up
with the newly loaded system.
If the update fails, a message will appear. Make a note of the con‐
tents, and take the appropriate action (refer to "Various messages"
on page 53).
44
Push
Push
Push