Table of Contents
Advertisement
2. Use the controller buttons to select and confirm the desired parameter item.
You can save these parameter settings as a preset setting (refer to "Save
Setting" on page 23).
Mic Sens
Use this parameter to set microphone sensitivity.
This parameter setting is valid only when the built‐
in or an external microphone is used for recording.
High: Select this high sensitivity option when
you record low level audio.
Mid: Select this option for normal level audio.
Low: Select this option if the input level is too high even after you
lower the level of the input source.
Mic Low Cut
If the recorder picks up faint noises, such as breath that hits the micro‐
phone directly, or outdoor wind or breeze, set this parameter to "On."
This parameter setting is valid only when the built‐in or an external
microphone is used for recording.
Limiter
The Limiter function is useful if the input level exceeds an appropriate
threshold.If an input signal level is excessive, the Limiter function will be
activated to compress the signal to an appropriate input level. This
parameter setting is valid only when the recording gain control is set to
"Manual" (see page 22).
Off: The Limiter function will be disabled.
Soft: A small amount of compression will be applied.
Hard: A significant amount of compression will be applied.
Bass
This parameter sets the amount of boost in the bass range of the input
sound. You can set the value in a range of −14 to +14dB in 2dB steps.
St.Enhanser
This parameter enables you to add presence and spaciousness to the
input sound by enhancing stereo effects.
Off: The enhancer will not be used.
Type1/2/3: The enhancing effect will become increasingly stronger
from 1 to 2 to 3.
21
Advertisement
Table of Contents
