Saving And Loading Settings On Usb Memory; Formatting Usb Memory; Saving And Loading Memory Banks; Saving To Usb Memory - Roland Classic C-380 Owner's Manual

Saving and Loading Settings on USB Memory

Formatting USB Memory

The process of preparing USB memory for use by the organ is called
"Formatting."
If the USB memory is not in the correct format for the organ, it
cannot be used by the organ.
* Before you use USB memory for the first time with the organ, you
must format the USB memory on the organ.
* When you format USB memory, all songs or settings that have been
stored on that USB memory will be lost. Once they're erased, the
songs cannot be recovered, so be sure to check the contents before
you execute formatting.
1.
Connect your USB memory to the USB memory connector
(p. 26).
2.
From the main screen, press the [Select/Menu] knob.
3.
Turn the [Select/Menu] knob to select "11 Save/Load (USB)."
fig.LCD012.eps
4.
Press the [Select/Menu] knob to access the "Save/Load
(USB)" screen.
5.
Turn the [Select/Menu] knob to select "Format USB
Memory."
fig.LCD060.eps
6.
Press the [Select/Menu] knob.
The following message will appear.
fig.LCD957.eps
7.
Press the [SET] piston to execute formatting.
If you decide to cancel the format operation, press the [Value/Exit
Menu] knob.
Never disconnect the USB memory before formatting has been
completed. Always wait until the "Executing" indication is no
longer shown.
8.
Press the [Value/Exit Menu] knob to return to the main
screen.
62

Saving and Loading Memory Banks

Memory banks can be saved to USB memory.
Memory banks M01–M20 can be saved or loaded together as one
set.
* Up to 999 sets of memory banks can be saved on one USB memory
device.
* For the C-380, not only the settings of the general memory pistons
but also the settings of the division memory pistons will be saved
and loaded.

Saving to USB Memory

Here's how to save all settings stored in the memory banks to USB
memory as a set.
1.
Connect your USB memory to the USB memory connector
(p. 26).
2.
From the main screen, press the [Select/Menu] knob.
3.
Turn the [Select/Menu] knob to select "11 Save/Load
(USB)."
fig.LCD012.eps
4.
Press the [Select/Menu] knob to access the "Save/Load
(USB)" screen.
5.
Turn the [Select/Menu] knob to select "Save Memory
Bank."
fig.LCD615.eps
6.
Press the [Select/Menu] knob to access the "Save
Memory Bank" screen.
7.
Assign a name to the combination of sounds you want to
save.
For details on how to assign a name, refer to "If you want to name
the data you're saving" (p. 61).
fig.LCD616.eps