Error Messages; List Of Shortcuts - Roland Classic C-380 Owner's Manual

Error Messages

Error Message
Write Data Error.
Write Error.
Media Unavailable.
Media Full.
Read Error.
Read Data Error.
Load Over Run.
Memory Full.
MIDI Buffer Full.
MIDI Off Line.
MIDI Error.
System Error.
USB Over Current.

List of Shortcuts

By using these shortcuts you can directly access a desired screen without going through a menu screen.
To access the screen
Demo screen
Pitch/Tuning screen
Voice Palette screen
Expression Pedal screen
USER/MIDI screen
Edit parameter save confirmation screen
Audio screen
Room Modeling screen
Console screen
Song Recorder screen
All shortcut operations must be performed from the main screen.
Meanings
You can only read the music file.
It can not be saved.
An error occurred during writing.
The USB memory's protect tab may be in the "Protect" (writing prohibited) position,
or the USB memory may not yet be initialized.
No USB memory is inserted.
Insert the USB memory and try again.
There is not sufficient free memory in the save destination.
Either insert other USB memory or delete unneeded files and try again.
An error occurred during reading.
The USB memory may be corrupted.
Insert other USB memory and try again.
Alternatively, you can format the USB memory. When you format USB memory, all songs or settings that have been stored on that
USB memory will be lost.
The file is unreadable.
The data format is not compatible with the C-330/C-380.
Data was not called up in time for playback of the song.
After waiting several seconds, you may be able to play back the song by pressing the [PLAY/PAUSE] button again.
The internal memory is full.
The C-330/C-380 cannot deal with the excessive MIDI data sent from the external MIDI device.
Reduce the amount of MIDI data sent to the C-330/C-380.
A MIDI cable has been disconnected.
Connect it properly and securely.
A MIDI transmission error has occurred.
Check the MIDI cable and connected MIDI device.
There may be a problem with the system.
Repeat the procedure from the beginning.
If it is not solved after you have tried several times, contact a Roland service center.
The USB connector was subjected to excessive current.
Make sure that there is no problem with the USB memory, then turn the power off, then on again.
Page
p. 28
p. 38–p. 41
p. 29–p. 30
p. 42–p. 45
p. 68
p. 73
p. 75
p. 35–p. 36
p. 27, p. 32,
p. 33, p. 77
p. 50, p. 60
Shortcut
While holding in the [SET] piston
Press the [STOP] piston
Press the [PLAY/PAUSE] piston
Press any key
Press the top or bottom of a division tablet
Operate the expression pedal
Operate the right or left kick switch
Press the top or bottom of the [USER/MIDI A] tablet
Press the top or bottom of the [USER/MIDI B] tablet
Press the general cancel piston [0]
Turn the [Master Volume] knob
Turn the [Reverb] knob
Press the bass coupler [BASS] piston
Press the melody coupler [MEL] piston
85