0128: 2Band Flanger; 0121: Auto Wah; 0103: Humanizer - Roland F-120R Implementation Manual

MIDI Implementation
●0128: 2Band Flanger
A fl anger that lets you apply an eff ect independently to the low-frequency and
high-frequency ranges.
No Parameter Value
1 Split Freq 0–16
Low Pre
2 0–125
Delay
Low Rate
3 0–1
Mode
4 Low Rate #1 1–127
5 Low Rate 0–21
6 Low Depth 0–127
7 Low Phase 0–90
Low
8 0–98
Feedback
High Pre
9 0–125
Delay
High Rate
10 0–1
Mode
11 High Rate #2 1–127
12 High Rate 0–21
13 High Depth 0–127
14 High Phase 0–90
High
15 0–98
Feedback
16 Balance 0–100
17 Level 0–127
●0121: Auto Wah
Cyclically controls a fi lter to create cyclic change in timbre.
No Parameter Value
1 Filter Type 0–1
2 Manual #2 0–127
22
Description
Frequency at which the
200–8000 Hz low and high ranges will be
divided
Delay time from when the
original sound is heard to
0.0–100.0 ms
when the low-range fl anger
sound is heard
When this is set to "note, " the
Hz, note eff ect is synchronized with the
tempo.
Rate at which the low-range
0.05–10.00
fl anger sound is modulated
Hz
(Hz)
Rate at which the low-range
note fl anger sound is modulated
(note)
Modulation depth for the
0–127
low-range fl anger sound
Spaciousness of the low-range
0–180 deg
fl anger sound
Proportion of the low-range
fl anger sound that is to
-98–+98% be returned to the input
(negative values invert the
phase)
Delay time from when the
original sound is heard to
0.0–100.0 ms
when the high-range fl anger
sound is heard
When this is set to "note, " the
Hz, note eff ect is synchronized with the
tempo.
Rate at which the high-range
0.05–10.00
fl anger sound is modulated
Hz
(Hz)
Rate at which the high-range
note fl anger sound is modulated
(note)
Modulation depth for the
0–127
high-range fl anger sound
Spaciousness of the high-
0–180 deg
range fl anger sound
Proportion of the high-range
fl anger sound that is to
-98–+98% be returned to the input
(negative values invert the
phase)
Volume balance of the original
D100:0W–
sound (D) and fl anger sound
D0:100W
(W)
0–127 Output volume
Description
Type of fi lter
Lpf: The wah eff ect will be
applied over a wide frequency
Lpf, Bpf range.
Bpf: The wah eff ect will
be applied over a narrow
frequency range.
Adjusts the center frequency
0–127
at which the eff ect is applied.
No Parameter Value
3 Peak 0–127
4 Sens 0–127
5 Polarity 0–1
6 Rate Mode 0–1
7 Rate #1 1–127
8 Rate 0–21
9 Depth 0–127
10 Phase 0–90
11 Low Gain 0–30
12 High Gain 0–30
13 Level 0–127
●0103: Humanizer
Adds a vowel character to the sound, making it similar to a human voice.
No Parameter Value
1 Drive Sw 0–1
2 Drive #2 0–127
3 Vowel1 0–4
4 Vowel2 0–4
5 Rate Mode 0–1
6 Rate 1–127
7 Rate #1 0–21
8 Depth 0–127
Input Sync
9 0–1
Sw
Input Sync
10 0–127
Threshold
11 Manual 0–100
12 Low Gain 0–30
13 High Gain 0–30
14 Pan 0–127
15 Level 0–127
Description
Adjusts the amount of the
wah eff ect that will occur
in the range of the center
0–127 frequency.
Set a higher value for Q
to narrow the range to be
aff ected.
Adjusts the sensitivity with
0–127
which the fi lter is controlled.
Sets the direction in which
the frequency will change
when the auto-wah fi lter is
modulated.
Up, Down
Up: The fi lter will change
toward a higher frequency.
Down: The fi lter will change
toward a lower frequency.
When this is set to "note, " the
Hz, note eff ect is synchronized with the
tempo.
0.05–10.00
Frequency of modulation (Hz)
Hz
Frequency of modulation
note
(note)
0–127 Depth of modulation
Adjusts the degree of phase
shift of the left and right
0–180 deg
sounds when the wah eff ect
is applied.
-15–+15 dB Gain of the low range
-15–+15 dB Gain of the high range
0–127 Output Level
Description
Off , On Turns Drive on/off .
Degree of distortion
0–127
Also changes the volume.
a, e, i, o, u
Selects the vowel.
a, e, i, o, u
When this is set to "note, " the
Hz, note eff ect is synchronized with the
tempo.
0.05–10.00 Frequency at which the two
Hz vowels switch (Hz)
Frequency at which the two
note
vowels switch (note)
0–127 Eff ect depth
Determines whether the LFO
for switching the vowels is
Off , On
reset by the input signal (ON)
or not (OFF).
Volume level at which reset is
0–127
applied
Point at which Vowel 1/2
switch
49 or less: Vowel 1 will have a
longer duration.
0–100
50: Vowel 1 and 2 will be of
equal duration.
51 or more: Vowel 2 will have a
longer duration.
Gain of the low frequency
-15–+15 dB
range
Gain of the high frequency
-15–+15 dB
range
L64–63R Stereo location of the output
0–127 Output level