Buttonhole With Gimp - JUKI HZL-F series Instruction Manual

Buttonhole with gimp

Hook
Pattern No. Direct 0
Buttonhole presser
Presser foot
foot (E)
1
2
3
4
5
6
Turn OFF the power switch
before replacing the presser
foot.
Buttonholes with gimp thread
prevent the buttonholes from
stretching and can make them
more secure. Use thread such as
hand-sewn buttonholes and similar
for gimp thread.
Pass the needle thread through under the
presser foot and then draw the thread to
the side of the presser foot.
Put one end of gimp thread into the
notch at the front right side of buttonhole
presser foot, pull the gimp thread under
the presser foot and thread it at the hook
of the presser foot.
After threading at the hook, pull the gimp
thread back under the presser foot and
put it into the notch at the front left side
of the presser foot firmly.
Bring down the needle to the sewing start
point and lower the presser foot.
Sew the buttonhole.
Pull the left gimp thread to take off slack
and cut excess gimp thread.
Attention
Notch
48
49