Initialization Of The Setting Data - JUKI IP-110 Type F Instruction Manual

19. INItIaLIzatIoN oF tHE SEttING Data

Data o� the fu�cto� sett�g tems ca� be retur�ed to the sta�dard set values.
[Function setting data initialization screen]
[Power switch OFF notification screen]
1. the neutral point compensation value of the pedal sensor is also initialized by carrying out the
initialization operation. It is therefore necessary to carry out the automatic compensation of the
neutral point of the pedal sensor without exceptions before using the sewing machine.
(refer to "18. automatic compensation of neutral point of the pedal sensor" p.
2. the machine head angle adjustment value is also initialized by carrying out the initialization oper-
ation It is therefore necessary to carry out the machine head angle adjustment without exceptions
before using the sewing machine.
(refer to "4. Sewing machine angle adjustment"
3. Sewing data programmed on the operation panel are not initialized by carrying out the initializa-
tion operation.
) Keep�g reset swtch 1 a�d cou�ter value
1 2
2) Whe� you press swtch 3 , the process for
3
3) O�ce the process s completed (approxmately
4) Tur� OFF the power swtch to ext from the �-
- 3 -
swtch (+) 2 held smulta�eously pressed, tur�
the power ON. The� the scree� s cha�ged over
to the fu�cto� sett�g data �talzato� scree�.
totally retur��g the fu�cto� sett�g data to the
sta�dard set values (�talzato� operato�) s
executed.
o�e seco�d later), the buzzer sou�ds (three
s�gle to�es, .e., blp, blp, blp) a�d scree� s
changed over to the power switch OFF notifica-
to� scree�.
Do not run the power oFF during the ini-
tialization operation. It can damage the
program of the main body.)
talzato�.
p.3.)
30.)