Rail Assembly; Fence Assembly And Adjustment - Jet JWBS-18QT Operating Instructions And Parts Manual

Rail Assembly

Referring to Figure 7:
1. Attach the front rail (F) to the cast iron table
with two 1/4" x 5/8" hex cap screws, two 1/4"
lock washers, and two 1/4" flat washers. The
screws should be in approximately the center
of the slot. Hand-tighten only at this time.
2. Attach the rear rail (G) to the table with two
1/4" x 5/8" hex cap screws, two 1/4" lock
washers, and two 1/4" flat washers. Screws
should be in approximately the center of the
slot. Hand-tighten only at this time.
3. Push the front and rear rails up as far as they
will go.
4. Using a 10mm wrench, tighten the four hex cap
screws holding the front and rear rails to the
table. Do not over-tighten the screws.
5. Attach the guide tube (H) to the front rail with
five 1/4" x 5/8" hex cap screws, five 1/4" lock
washers, and five 1/4" flat washers. Screws
should be in approximately the center of the
slot.
Hand-tighten the guide tube only at this time.
You will be instructed to secure it later in the
Fence Assembly and Adjustment section.

Fence Assembly and Adjustment

Assembling the Fence to Fence Body
Referring to Figure 8:
1. Attach the fence (A) to the fence body (B) with
four 5/16" x 3/4" socket head cap screws (C),
four 5/16" lock washers (D), and four 5/16" flat
washers (E). Hand-tighten only at this time.
11
Figure 7
Figure 8