Page 2
CE-Konformitätserklärung Déclaration de Conformité CE Product / Produkt / Produit: Woodworking Band Saw / Holz-Bandsäge / scie à ruban à bois JWBS-14Q Brand / Marke / Marque: Manufacturer / Hersteller / Fabricant: JPW (Tool) AG, Tämperlistrasse 5, CH-8117 Fällanden Schweiz / Suisse / Switzerland We hereby declare that this product complies with the regulations Wir erklären hiermit, dass dieses Produkt der folgenden Richtlinie entspricht...
Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for the owner and operators of a JET JWBS-14Q band saw to promote safety during installation, operation and maintenance procedures.
When working on the machine, all safety mechanisms and Keep work area well lighted. covers must be mounted. The machine is designed to operate in closed rooms and must be placed stable on firm and levelled ground. In addition to the safety requirements contained in these operating instructions and your country’s applicable Make sure that the power cord does not impede work and regulations, you should observe the generally recognized...
H Wheel cover 4.4 Dust emission Mitre gauge J Fence carrier rail The band saw JWBS-14Q has been dust emission inspected. K Fence At an air velocity of 20 m/s on the dust port dia 100mm: L On/Off magnetic switch...
4.5 Content of delivery Machine table Fence Fence support rails Parallel cutting device Mitre gauge Dust port 100mm Assembly bag Saw blade 10 mm Operating manual Spare parts list Fig 3 5. Transport and start up Attach the guide rail (H) with 5 hex cap screws, 5 spring washers and 5washers.
Bring the upper blade guide to a distance of approx 0,5 cm to the workpiece. Use a feeding template to safely guide small and narrow 5.2 Mains connection workpieces. Mains connection and any extension cords and plugs used Use a suitable wedge to prevent round timber from turning must comply with the information on the machine licence under the pressure of the cut plate.
For narrow shallow cuts on the rip fence a self-made auxiliary Choose a suitable sawblade, according to the cutting fence (E, Fig 8) made of cutable material ( e.g. wood, plastic, operation and according to the material to be cut. aluminium) must be used.
Page 9
Fig 11 A- Regular tooth: The most common used tooth shape. 0° rake angle. Suited for cut-off and contour sawing of most materials. For cutting materials where a fine cut is required. B- Skip tooth: Fig 13 Widely spaced teeth, to prevent clogging. 0°rake angle. Blade material: For resawing and ripping thick stock, especially soft woods.
Page 10
7.3 Blade tracking adjustment 7.5 Blade guide adjustment Blade tracking shall never be performed when the machine is Blade guide adjustment shall never be performed when the running. machine is running. The sawblade must run on the centre of the rubber tyres (Fig Position the guide assembly forward/ backward so that the teeth keep a distance of appr.
Page 11
360°, a complete circle, as you move it down towards the floor (Fig 19). Fig 20 JET Stock number: 135010 The table insert may not project above table surface. Saw blades: The servicing of saw blades should only be performed by a trained person.
Page 12
11. Available accessories Refer to the JET-Pricelist for various saw blades. Stock number 709209 Foldable roller stand. 12. Safe operation See appendix A (on the last pages of this operating manual) A.1: Performing high cuts A.2.: Performing diagonal cuts A.3.: Tenon cutting A.4.: Cutting of wedges...