Rail Assembly (Optional Accessory); Fence Assembly And Adjustment (Optional Accessory) - Jet JWBS-16B Operating Instructions And Parts Manual

Rail Assembly (optional accessory)

1. Attach the front rail (A, Fig. 8) to the cast iron
table with two 1/4" x 5/8" hex cap bolts, two
1/4" lock washers, and two 1/4" flat washers.
Bolts should be in approximately the center of
the slot. Hand tighten only at this time.
2. Attach the rear rail (B, Fig. 8) to the table with
two 1/4" x 5/8" hex cap bolts, two 1/4" lock
washers, and two 1/4" flat washers. Bolts
should be in approximately the center of the
slot. Hand tighten only at this time.
3. Push the front, and rear rails up as far as they
will go.
4. Tighten the four hex cap bolts holding the front,
and rear rails to the table. Do not over tighten
the bolts.
5. Attach the guide tube (C, Fig. 8) to the front rail
with five 1/4" x 5/8" hex cap bolts, five 1/4" lock
washers, and five 1/4" flat washers. Bolts
should be in approximately the center of the
slot.
Fence Assembly and Adjustment
(optional accessory)
1. Attach the fence (D, Fig. 9) to the fence body
(E, Fig. 9) with four 5/16" x 3/4" hex cap bolts,
four 5/16" lock washers, and four 5/16" flat
washers.
2. Thread a hex nut (G, Fig. 10) onto the pad's
threaded stud (H, Fig. 10) and insert through
the fence and rear hook (I, Fig. 10). Secure in
place using a hex nut, lock washer and flat
washer (J, Fig. 10).
Note: The hook should be adjusted so that it
overlaps the rear rail by approximately 1/8".
3. Place fence assembly onto the guide tube.
The rear hook should engage the rear rail.
13
Figure 8
Figure 9
Figure 10